The newly-purchased floor scrubber cannot be used directly. It can be used normally after installing parts and components, and it can be used after a routine inspection. Routine inspection before using the new floor scrubber
1. Make sure that the battery has sufficient power;
2. The battery must not be weak or dead
3. Put down the squeegee and adjust the squeegee to ensure that the squeegee is at 90° to the ground, otherwise it will cause poor water absorption or premature wear of the rubber strip;
4. Install the needle plate and the white clean pad.
5. Raise the brush plate and squeegee, turn on the switch, press and hold to drive backward, and then push the emergency stop button to confirm that the scrubber can automatically move forward for a certain distance after emergency stop to ensure the safety of the operator.
